Enum sentry::SessionMode

pub enum SessionMode {
    Application,
    Request,
}

The Session Mode of the SDK.

Depending on the use-case, the SDK can be set to two different session modes:

• Application Mode Sessions: This mode should be used for user-attended programs, which typically have a single long running session that span the applications’ lifetime.

• Request Mode Sessions: This mode is intended for servers that use one session per incoming request, and thus have a lot of very short lived sessions.

Setting the SDK to request-mode sessions means that session durations will not be tracked, and sessions will be pre-aggregated before being sent upstream. This applies both to automatic and manually triggered sessions.

NOTE: Support for request-mode sessions was added in Sentry 21.2.

See the Documentation on Session Modes for more information.

Variants

Application

Long running application session.

Request

Lots of short per-request sessions.

Trait Implementations

impl Clone for SessionMode

fn clone(&self) -> SessionMode

Returns a copy of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for SessionMode

fn fmt(&self, f: &mut Formatter<'_>) -> Result<(), Error>

Formats the value using the given formatter.

impl PartialEq for SessionMode

fn eq(&self, other: &SessionMode) -> bool

Tests for self and other values to be equal, and is used by ==.

fn ne(&self, other: &Rhs) -> bool

Tests for !=. The default implementation is almost always sufficient, and should not be overridden without very good reason.

impl Copy for SessionMode

impl Eq for SessionMode

impl StructuralPartialEq for SessionMode